Hengsen DDF-N series Motorized valve

ODM / OEM-teenus

high Capacity

Low Noise

1-aastane müügijärgne teenindus

What does DDF-K do?

DDF-N series motorized valve are available for controlling the central air conditioning and heating system's opening and closing tocontrol the room temperature. The control valve is driven by the

unidirectional hysteresis synchronous motor and adopts spring reset. The actuator is normally closed when it doesn't work. If it needs to work, the thermostat will provide a signal of opening, and then the actuator will get the power to work. Opening the valve, the cold and hot water will come into the fan coil to provide the cold or hot air. When the set temperature is achieved, the thermostat will cut off the actuator 's power, and then the reset spring can close the valve to stop the water flow into the coil. So the room temperature is always maintained within the set range by

thevalve's opening and closing.



Toote omadused

◆ Korpuse materjal: sepistatud messing

◆ Varre materjal: roostevaba teras

◆ Sealing material: nitrile rubber (NBR)

◆ Töökeskkond: külm/kuum vesi

◆ Vedeliku temperatuur: 2-94 ℃

◆ Rõhk: 1.6 MPa

◆ Ümbritseva õhu temperatuur: 0–65 C℃ maksimaalne suhteline õhuniiskus ei ole kaste

◆ Reisiaeg: 11–15 sekundit

◆ Mootori pöördemoment: >800gf.cm

Toote omadused

●Kõrghoonete puhul tuleks alumisel harul kasutada reduktorventiili.

●Mootori korpus peaks takistama vee imbumist sisse. Seega, kui klapp on paigaldatud, ei tohi täiturmehhanism olla toru all.

●Kui klapp on paigaldatud vertikaalsele torule, peab mootori korpus olema kaitstud tilkumise eest.

●käsihoob; Kui käsihooba liigutatakse aeglaselt mööda noolt ja surutakse sälku, on klapp tavaliselt avatud. Iga kord, kui vool läbib mootoriga ventiili esimest korda, lähtestatakse käsihoob automaatsesse asendisse.

●Kui täiturmehhanism pole ventiili korpusele eelpaigaldatud, lükake paigaldamisel esmalt juhthoob noole suunas alumisse soonde, vajutage ajami mustale nupule, asetage see klapi korpusele ja vabastage see, seejärel seda saab paigaldada. Kui teil on vaja lahti võtta, korrake ülaltoodud samme.

●Märkus: veevoolu suund peab olema sama, mis noolega klapi korpusel; täiturmehhanismi ei tohiks paigaldamise ajal kasutada jõu tugipunktina.

toote-pilt